Am looking for some help in creating my own FT SSD's using the shipbits like
in the books,but dont know how.
I have Windows XP with Paint and some shipbit zip files from Beth Fulton
(thanks!)--any way to utilize these to make my own SSD's?
I tried a couple of the programs to do this but cannot get them to
work--sont know if I am doing something incorrectly,or noit at all,but
have
not been able to figure it out--any help from listers is appreciated.
Thanks,
I use Paint to create a JPG file of the SSD, and then embed the jpg file into
either a Word or Open Office document. If you have Word it works well, if not
Open Office can be downloaded from www.openoffice.org for free. After I get
the SSD in the document, I normally insert other information, such as the
weapons charts at the bottom half of the page. If you would like to see an
example or two contact me off list and I will send them to you.
Karl
[quoted original message omitted]
It is very straight forward. open two sessions of paint. Into one sessions of
paint load ship bits. draw your ship outlin in paint. Cut and paste the ships
systems from the other session.
Note ctrl-C and ctrl-v can be used as cut and paste short cuts
Andy
I have a few samples on my site:
http://groups.msn.com/ConfusionCentral411
> From: "Mark & Staci Drake" <markandstaci@charter.net>